exhaust housing swap??
#11
Re: exhaust housing swap??
Originally Posted by ShoofIsLudin
pm'd
compressor inlet measure ~52mm
and the turbine outlet measure ~50mm
I have an extra compressor wheel I think it is...and a shitty as plastic dial caliper that gives "~measurements"
compressor inlet measure ~52mm
and the turbine outlet measure ~50mm
I have an extra compressor wheel I think it is...and a shitty as plastic dial caliper that gives "~measurements"
that is if you do stil have it
#12
Re: exhaust housing swap??
the wheel is from the same turbo, just a spare one that I got from someone, and its a compressor wheel
at the widest point its 60mm
and at the narrowest point of the fins its about 47mm
If its not what you're looking for...no worries. It'll put me close to 270whp in my stock h22, I just don't know how much boost i'll have to run to get around there, so it'll be fine for me until I can afford a build project.
at the widest point its 60mm
and at the narrowest point of the fins its about 47mm
If its not what you're looking for...no worries. It'll put me close to 270whp in my stock h22, I just don't know how much boost i'll have to run to get around there, so it'll be fine for me until I can afford a build project.
Thread
Thread Starter
Forum
Replies
Last Post
RedCavz
General Discussion
14
03-30-2006 05:19 PM
coldfusion
Turbo Parts For Sale
4
07-20-2005 03:28 PM
krskid
Wanted
6
08-02-2004 08:18 PM