exhaust housing swap??
AiResearch/Garrett M10 t4
i have a t4 . 60 ex .81 its got a 3in v band no shaft play the ex side is far to big for my d16 .. i have searched doing a swap over to a t3 exhasyed side but cat find any thing :3. so what im asking is has anyone on here done a swap on this turbo? can it be done? i want to drop down to like 63 ar size thanks for any help |
Re: exhaust housing swap??
|
Re: exhaust housing swap??
looking ro swap over sides but i did bid on it .
|
Re: exhaust housing swap??
You'll have to convert it to a T3 turbine wheel if you want to run a T3 hotside. Hence the T3/T4. Your predicament isn't uncommon haha. The T4 compressor is perfect, but the T4 turbine wheel and hotside aren't. It's about $300 to do it properly. If it's a small enough T4 turbine wheel you could probably find a stage 5 (T350) turbine housing and have it bored slightly over for the T4 turbine. It would still spool like ass with the T4 turbine wheel in it though.
|
Re: exhaust housing swap??
bump
|
Re: exhaust housing swap??
wanna trade a nissan t3 for ur t4?
|
Re: exhaust housing swap??
what ar sizes is it and is there any shaft play
|
Re: exhaust housing swap??
6 Attachment(s)
don't know the AR size. Yes there's a lil shaft play. Its a water and oil cooled Nissan t3 from a single turbo z31. Its got a goofy 7 bolt DP flange that is like $30
Where are you located? Attachment 10289 Attachment 10290 Attachment 10291 Attachment 10292 Attachment 10293 Attachment 10294 |
Re: exhaust housing swap??
i have two homes lol when im in school 60188 but my mom and dad live in 50707 so check on both places for shipping
wish i knew the ars on that tho |
Re: exhaust housing swap??
pm'd
compressor inlet measure ~52mm and the turbine outlet measure ~50mm I have an extra compressor wheel I think it is...and a shitty as plastic dial caliper that gives "~measurements" |
All times are GMT -5. The time now is 11:59 PM. |
© 2024 MH Sub I, LLC dba Internet Brands