dsm 450 injector install
#1
dsm 450 injector install
ive been searching google and i searched all over here cant find a good dsm 450 injector install how to i got obd1 i know i have to dremel my intake a little bit dont know how to do the wiring can someone help me out thanks
#2
Re: dsm 450 injector install
1 Dremel SEALS that go into intake mani....just a little bit
2 bolt in injectors
3 wire in a resistor box or 10 watt 10 ohm resistors
4 burn chip to run 450cc injectors
5 wack off because you have 450cc injectors
2 bolt in injectors
3 wire in a resistor box or 10 watt 10 ohm resistors
4 burn chip to run 450cc injectors
5 wack off because you have 450cc injectors
#7
Re: dsm 450 injector install
Originally Posted by rsmith2786
1 Dremel SEALS that go into intake mani....just a little bit
2 bolt in injectors
3 wire in a resistor box or 10 watt 10 ohm resistors
4 burn chip to run 450cc injectors
5 wack off because you have 450cc injectors
2 bolt in injectors
3 wire in a resistor box or 10 watt 10 ohm resistors
4 burn chip to run 450cc injectors
5 wack off because you have 450cc injectors
1ok
2ok
3 dont know how to wire it up what about the resistor box from an older integra?
4 afc
5 done
#8
Re: dsm 450 injector install
I'm pretty sure any Honda resistor box will do...
There are a few different ways to do it. I wired mine up through the wires near the shock tower (don't remember what it's called)...
I'll see if I can find a write up for you really quick, rather than explaining it myself...
Okay, here's the one I followed... make sure you test the continuity and go by that, don't just follow the Hondata site, my car was different!
http://www.honda-tech.com/zerothread?id=517274
There are a few different ways to do it. I wired mine up through the wires near the shock tower (don't remember what it's called)...
I'll see if I can find a write up for you really quick, rather than explaining it myself...
Okay, here's the one I followed... make sure you test the continuity and go by that, don't just follow the Hondata site, my car was different!
http://www.honda-tech.com/zerothread?id=517274
#9
#10
Re: dsm 450 injector install
yeah i forgot about modifying the clips...damn. But as far as the resistors go you can follow the injector plugs yellow wire with a black stripe. Just wire a radio shack resister inline with this wire and your good do go. I hear the resisitor pack looks nicer but if you do a nice organized job with the resisitors it will look good too.