whiterice

i prefer the resistor box.
https://www.homemadeturbo.com/forum/...9608#msg349608

Paul99EX

what do you mean about using a drimmel on the injectors? what do you need to drimmel?? pref an mspaint pic please

koreanwilcox

I didn't use a dremel on mine, I just used a sharp knife... I'll try to draw a picture reall quick... it's a small tab on the inside of the clip...

rsmith2786

Although i have mad sicc ms paint skills i dont have time right now. Basically sand down the inside of the seal where the injectors slide in and make it a little bigger. Just have a 450cc injector with you when you do this so you can test for a snug fit and keep sanding till you get there.

koreanwilcox

Okay, as far as the clips go, here's what you have to modify...

This is a super fantastic drawing of an injector, DSM 450 if you couldn't tell, showing the part you have to shave off so it works with the stock clips...



Good thing I'm bored right now...

Oh, and you have to bore out the seals, but that's so self-explainatory it doesn't deserve a super fantastic drawing...

Paul99EX

so im shavin off a little tab off the clips? im still confused, haha, i just dont wanna fuckup my injectors

Donald125

you shave that little bump ON the injector itself.

koreanwilcox

You don't have to modify the clips... just shave the circled tab off the actual injector...

If you had the clips and injectors in your hands, it would be pretty obvious what part you need to modify... you won't mess up your injectors by doing this, it's nothing but a plastic tab that you have to remove..

Paul99EX

this thing? (sorry pics kinda blurry)

[img width=600 height=500]http://www.we-todd-did-racing.com/wetoddimage.wtdr/wODg2MzMyNnM0MTNkZmQzMXk1NDE%3D.jpg[/img]