Re: Downpipe clearence need help
 

ahh if i read this about a minute before ordering a big roll from hamiltonmarine.com, ill try to go with the 1.5 and if it does touch the alternator ill have it banged a tiny bit and heat wrap it, also what do i use 2 hold the wrap just some regulat hose clamps?

Re: Downpipe clearence need help
 

Sorry. Uhhhh....yea I guess. Wrap it tight kinda like you would for an ankle wrap. Starting and layering over it, stretching, pulling tight, wraping down on an angle a little further down on the downpipe, repeat. Hose clamps on the ends I guess. I never did it, but it sounds savvy. Good luck and post in General Disscussion when it's done with some numbers. A Hyundai.....HMT has expanded.


JP

Re: Downpipe clearence need help
 

well this exhaust shop out back of this dudes house was taklin about 300$ sayin that it may take along time to make somethin 2 fit thats nuts

Re: Downpipe clearence need help
 

I have an Acura Legend and dont have enough room for the dowpipe under the tranny so I am gonna just dump it out in front of the front wheel. Maybe you could do something similar.

Re: Downpipe clearence need help
 

its that i need my o2 sensors for my car to run correctly

Re: Downpipe clearence need help
 

can you make the downpipe go over top of the alternator?

Re: Downpipe clearence need help
 

no clue ill ask the muffler guy tommrowo

Re: Downpipe clearence need help
 

Is that manifold off of the scoupe turbo? I have the same engine in my winter beater na scoupe.

Re: Downpipe clearence need help
 

yea its the turbo scoupe manifold, the scoupes use the same 1.5L alpha motors, the turbo scoupe uses a t15 oil/water cooled around 115 hp at like 5 psi with oil sqirter pistons but the compression sucks .