Custom Methyl Hydrate/Water Injection
#1
Custom Methyl Hydrate/Water Injection
over the past few weeks i have put together a kit that my friend and i finally finished installing tonight. its made of basically a snow performance pump and controller. the lines i had to make so i can take the car to the track. they were kind of a pain to create but in the end it all worked out alright.
the only problem im having right now is figuring out what pressure to run the pump at. as you can see im going to be doing direct port injection. at the moment i have 4x100ml/min injectors. i quickly rigged the pump up to power to create a current and see just how much water it injected. IT WAS ALOT. i think maybe too much. it kinda scared me. the pump was almost turned down all the way. now mind you ill be starting at about 50/50 pure methyl hydrate/water. is this a good place to start? does anyone have some experience with this? i cant base the amount injected to anything i have seen so far so i guess ill just go conservative and see what happens. :thumbup:
the only problem im having right now is figuring out what pressure to run the pump at. as you can see im going to be doing direct port injection. at the moment i have 4x100ml/min injectors. i quickly rigged the pump up to power to create a current and see just how much water it injected. IT WAS ALOT. i think maybe too much. it kinda scared me. the pump was almost turned down all the way. now mind you ill be starting at about 50/50 pure methyl hydrate/water. is this a good place to start? does anyone have some experience with this? i cant base the amount injected to anything i have seen so far so i guess ill just go conservative and see what happens. :thumbup:
#2
Re: Custom Methyl Hydrate/Water Injection
Your Setup lewks Awsome! hope it runs great. i have been doing my own WI research and i think u will find beter/more/accurate info on a website that is dedicated to water meth injection check out http://www.waterinjection.info/
Good Luck!
Good Luck!
#5
Re: Custom Methyl Hydrate/Water Injection
very clean install and nice setup.
however, the one thing i would have done different would be to angle the WI nozzles towards the head more rather than a 90* shooting right into the bottom of the intake runner.
however, the one thing i would have done different would be to angle the WI nozzles towards the head more rather than a 90* shooting right into the bottom of the intake runner.
#6
Re: Custom Methyl Hydrate/Water Injection
thanks guys, if you look closely the jets are not perpendicular the runners. notice they are straight up and down with "level" but the runners are on the 30* angle. check out a side view and you will see!!