Can I run 6 psi on a stock LS?
#14
Re: Can I run 6 psi on a stock LS?
Originally Posted by davcivic
I'm assuming you have a b20 block and an LS head, right?
You can run 10 psi but not with an FMU. If you are only thinking about using an FMU do not go past 6psi. I didn't read the whole thing, but you also need a missing link or some check valves for your map sensor, so it doens't read boost, or positive preassure.
If you decide to go with the AFC, you should also get bigger injectors, the DSM 450cc injectors are good for 10-12 psi safely, if tuned properly. This is one of the best options if you do not know how to tune and do not want to learn. Go to a shop get it dyno tuned, and don't touch anything.
Uberdata is free, but you would need to go with an OBD1 ECU, and someone that can install the chip and tune it for you, if you can't do it yourself.
Hope this helps
You can run 10 psi but not with an FMU. If you are only thinking about using an FMU do not go past 6psi. I didn't read the whole thing, but you also need a missing link or some check valves for your map sensor, so it doens't read boost, or positive preassure.
If you decide to go with the AFC, you should also get bigger injectors, the DSM 450cc injectors are good for 10-12 psi safely, if tuned properly. This is one of the best options if you do not know how to tune and do not want to learn. Go to a shop get it dyno tuned, and don't touch anything.
Uberdata is free, but you would need to go with an OBD1 ECU, and someone that can install the chip and tune it for you, if you can't do it yourself.
Hope this helps
Thread
Thread Starter
Forum
Replies
Last Post
Loserkidwac
Forced Induction
23
08-25-2006 02:14 AM
spooolin
Engine Management
5
11-02-2004 09:11 PM