Building a 1.5L Mini Me Turbo!!!! ....bring your wisdon and experiece in here!!!
#21
Re:Building a 1.5L Mini Me Turbo!!!! ....bring your wisdon and experiece in here
Guess whos back?
OK, well they are inside the rods, and then the bottom part of the rod gets bolted to the top. My friend's car spun a bearing, and he heard the knock, and turned the car off, within 2 secs!!, and then when he took the motor apart, the bearing melted to the rod!! And it fucked up his Crank!
To install you got to take the rods off, and undo the two rod bolts, then take off.
OK, well they are inside the rods, and then the bottom part of the rod gets bolted to the top. My friend's car spun a bearing, and he heard the knock, and turned the car off, within 2 secs!!, and then when he took the motor apart, the bearing melted to the rod!! And it fucked up his Crank!
To install you got to take the rods off, and undo the two rod bolts, then take off.
#22
Re:Building a 1.5L Mini Me Turbo!!!! ....bring your wisdon and experiece in here
i know there are rod bearings, but arent there main crank bearing as well ... where the crank lays in the jurnals which bearings are the ones to fail usualy
#24
Re:Building a 1.5L Mini Me Turbo!!!! ....bring your wisdon and experiece in here
i have a ~160k d15b2 converted to mpfi. it's been turboed since last december. no problems so far.
setup is: t25 @ 8-9psi, 3degrees retard, 1step colder plugs, afc, dsm 450s, dsm bov, johnnyracecar intercooler, stock but new fuel pump, untuned but erred rich side. i dont care if it blows up, but im not going to deliberately make it happen. i did compression check recently and it was all even across.
setup is: t25 @ 8-9psi, 3degrees retard, 1step colder plugs, afc, dsm 450s, dsm bov, johnnyracecar intercooler, stock but new fuel pump, untuned but erred rich side. i dont care if it blows up, but im not going to deliberately make it happen. i did compression check recently and it was all even across.
Thread
Thread Starter
Forum
Replies
Last Post
robs99si
Engine Management
6
09-02-2004 07:07 AM