Bitch ass oil leak
#11
Guest
Posts: n/a
Re: Bitch *** oil leak
Originally Posted by myshtern
I think what I'll try is wrap take the line off and wrap a -----ton of high temp RTV on the pan fitting and slide the line over it. Hopefully it will make a seal in that junction. If that doesnt work, I'll try what civicsi said with a more flexible line.
#15
Re: Bitch *** oil leak
Stealth already told you that the fitting is too small for the line. I had the same problem. -AN lines have Stainless steel braiding which make it very difficult for the hose clamp to ensure a ploper clamp. You have three options:
1) Use a rubber heater hose if you are using a hose clamp
2) Use -AN fittings with -AN line
3) Use the correct size barb with the supplied -AN line (5/8")
Done deal
1) Use a rubber heater hose if you are using a hose clamp
2) Use -AN fittings with -AN line
3) Use the correct size barb with the supplied -AN line (5/8")
Done deal
#18
Re: Bitch *** oil leak
Originally Posted by jagojon3
My stealthmode return leaked a liiiiiiiitle bit at first, but then all I did was tighten the ---- out of the hose clamp with a socket (not a screwdriver like the first time) and it's all gravy baby
#19
Re: Bitch *** oil leak
The weld isnt leaking, I checked it pretty thuroughly before I put the oil pan back on. The bottom fitting is one that I actually got from Lowes (steel) and had to grind some around the sides for the line to fit over it. I guess I'll try to tighten that bitch with a socket too.
I'm far too lazy to relace that ---- with an AN fitting.
I'm far too lazy to relace that ---- with an AN fitting.
Thread
Thread Starter
Forum
Replies
Last Post
Project CRXtacy
General Discussion
68
10-05-2007 06:44 AM
scottsi
General Discussion
42
06-22-2005 02:03 PM