Bad Wastegate on 14b?
#1
Bad Wastegate on 14b?
Just got a 14b yesterday and the wastegate is dented in a couple spots. I can't move the rod on it in and out in it, don't know if you are able to, and was wondering if there is a way to test it? Also is there a writeup on how to modify the arm to run lower boost?
#2
Guest
Posts: n/a
Re: Bad Wastegate on 14b?
It's going to be firm, pull harder. You should be able to pull it out some. You can test it by hooking it up to an air compressor set at 8 psi, it should open. Do some searching, there's been a few threads about messing with the actuator arm.
Thread
Thread Starter
Forum
Replies
Last Post