So I picked up 2 burnt ECUs today for free and after looking at them... The PO6 doesnt look so bad, Just one burnt up resistor (R135). The 28 looks done, QM1 and QM2 are toast but the rest of the board is clean. Basically my question is can I take parts of the p28 ecu to convert the Po6 to VTEC and if tso which parts? FYI: The PO6 has a 1500 board. Let me know if I need to post up some pics if it'll help. Thanx guys.

 

I would just try replacing the burn up resistor on the po6, and see if it works, then get a vtec conversion kit specifically for that board.

 

yeah you can, either go on pgmfi.org and look at the parts needed and the location there needed to be put then take them from the p28.

 

Are they both non-working for sure?