Is This A Bad Idea??
#11
Re: Is This A Bad Idea??
Originally Posted by tr4cti0n.i55ues
what kind wastegate are you running. just make sure that it is un hooked. the turbo will overspin if you dont. do this and just baby it home. it should be fine just
#14
Re: Is This A Bad Idea??
Originally Posted by rawr
Dude. just ------- install everything. Drive it open turbo to the shop (no downpipe). Then have them weld you up a down pipe. comprehend?
You need at least 3 things welded: BOV, Oil Pan Nipple & Downpipe.
You can figure out where your BOV & Nipple go well in advance of your install day. Pull the pan & take that and your IC pipe/BOV flange to your welder and have them welded. Cap the nipple and reinstall the pan.
When it comes to install day, put your kit together completely MINUS the downpipe. Drive the car over to your welder (again) and have them fab the downpipe with the turbo on the car. It will be loud, but you'll save a lot of time, trips and headaches.
You're making it way too hard. :1
Thread
Thread Starter
Forum
Replies
Last Post
BLACK_DEL_SOL
General Discussion
4
05-06-2004 11:39 AM
fongaroos
Engine Management
5
04-16-2003 11:59 PM