14b fittings
#2
Re:14b fittings
Well, the 14b uses a metric fitting, and a NPT brass fitting wont work. What we do is use the factory banjo bolt fitting with the little pipe cut off and a barb put on it. I havent found a fitting that goes into the 14b housing. I have seen some people use a -AN fitting, but I dont know which size, or if they had to tap it out or what...
Also for the return line, you are going to need to use the factory return line, then chop it off.
Jeff
Also for the return line, you are going to need to use the factory return line, then chop it off.
Jeff
#4
Re:14b fittings
I would go with a -4 that is easy to attach to the back of the block and run your line. but I dont know what you are going to do when you get to the turbo. I really dont know what size the 14b threads are, and if they will accept -an fittings or Not. We have always been so low-budget that we just use the factory parts, with some rubber line and hose clamps..
Jeff
Jeff
Thread
Thread Starter
Forum
Replies
Last Post
ward
Forced Induction
3
04-09-2006 10:31 PM