Welder Question
#1
Welder Question
Would this welder work well for manifold fabrication??
http://www.harborfreight.com/cpi/cta...emnumber=91811
Input voltage: 220 volt , 18 amps, single phase, DC output amperage: 130 (TIG), 90 (ARC), Rated duty cycle: 35% @ 130 amps, 6 ft. 2 in; Electrodes: 1/16'' tungsten (for best results); TIG torch, 9 ft. 1 in. ARC torch, Overall dimensions: 14-3/4" L x 5-1/8" W x 6-7/8" H; Weight: 17 lbs.
http://www.harborfreight.com/cpi/cta...emnumber=91811
Input voltage: 220 volt , 18 amps, single phase, DC output amperage: 130 (TIG), 90 (ARC), Rated duty cycle: 35% @ 130 amps, 6 ft. 2 in; Electrodes: 1/16'' tungsten (for best results); TIG torch, 9 ft. 1 in. ARC torch, Overall dimensions: 14-3/4" L x 5-1/8" W x 6-7/8" H; Weight: 17 lbs.
Thread
Thread Starter
Forum
Replies
Last Post
Turblow
Fabrication
21
02-13-2007 05:20 AM
crx2fast
General Discussion
0
01-22-2007 12:50 AM