My T3/T4 uppipe build...
#1
My T3/T4 uppipe build...
I am using a Borla NA header and will be boosting my NA daily driver soon. Don't worry, I have a built 2.5 going in eventually.
Anyway, here are some mock up photos.
Some issues that have arisen are A- I built it while using a NON-ABS vehicle for measurement. But the wagon its going into is ABS, so I need to move it a few inches. And B- there might be some axle issues. But probably not.
So I would finish it tonight, but the damn cold saw blade has gotten so small, I can't cut anything! ol:
Anyway, here are some mock up photos.
Some issues that have arisen are A- I built it while using a NON-ABS vehicle for measurement. But the wagon its going into is ABS, so I need to move it a few inches. And B- there might be some axle issues. But probably not.
So I would finish it tonight, but the damn cold saw blade has gotten so small, I can't cut anything! ol:
#7
Re: My T3/T4 uppipe build...
Project on hold. Its a PITA to do it without the engine in the wagon. And then its a PITA because I don't have lift.
Yet......
Getting one soon! $500!!!!!
This style. Picture not actual lift....
Yet......
Getting one soon! $500!!!!!
This style. Picture not actual lift....
Thread
Thread Starter
Forum
Replies
Last Post
Gold DA9
General Discussion
1
08-15-2008 11:58 AM
catch.can
General Discussion
87
05-22-2006 11:52 AM