So I'll have to make my own flanges for my turbo, bmc and wier havent responded to my pms and other online c&c and whatever sites are ---- ton expensive.
Should I use SS? And how thick should it be? I am sure I can cut it to approxiamtely the right shape and then drill holes where I need them and then take a million hours to dremel in the right shaped port. I have no $$ but lots of time, so I'll probably do that. Anyone make their own flanges?

 

Should at least be 3/8 of an inch. I just used mild steel plate.

 

I'm about to make my own and was told to use 3/8" minimum , mild steel.

https://www.homemadeturbo.com/forum/...?topic=57378.0

sorry to say but, search
didn't even have to scroll but half a page

 

I didnt search in the slightest...was searching "Stock map sensor" "stop fuel pump" "450's on stock engine"
Haha, spent the last week on here just reading and reading and reading. Thanks for the info, and not bieng a *****.

 

Use mild steel not stainless. You're going to ---- yourself in the *** if you try to dremel 3/8" thick steel.
Draw the entire flange out on your steel, then take it to your local fab shop with a plasma cutter or even oxy/acetalyne torch and have them cut the flange out for you. It would take them 10 minutes and probably cost you $20. Then just grab a drill and drill out those holes yourself.

 

What type of flange are you trying to make first off?

 

LOL, yeah seriously. I've got b-series and d-series in stock.

 

Your hyper link in your sig doesn't work. I'd like to see your flanges.

 

for this here turbo...I need a turbo to mani flange and a DP flange.

https://www.homemadeturbo.com/forum/...?topic=57768.0

 

I fixed that link and my flanges are here: http://www.discreteautos.net/racing/flanges/