did a search with no good results. has anyone tried this? where can you get the tubing to weld onto the yokes? want to make one for a set up runing about 300 hp. it will be short so i don't think vibration would be an issue, if it is, i'll send it to get balanced.

 

i dont know where you are located but do you have a store similiar to farm and fleet, or other farm/general supply. i have seen just blank shafts that you cut to size and weld the joint on.

 

thanks for your help. i'm in northern california. closest to that store would probably be ace hardware or orchard supply, but, i've never seen blank shafts there.

 

what exactly are you looking for my dad makes driveshafts for a living and would hook you up probably.

 

You should also look into buying a aftermarket driveshaft loop also. lol.

 

i saw them do it on that show extreme 4x4 on spike once. they used square tubing. seemed to work, but they dont go faster than 10mph or so

 

angle iron to brace the driveshaft straight.

 

what?

 

you lay it angle facing away so you get a somewhat dead on alignment.

 

<O>

thats the best way i can think of to describe what he means. you can use a couple hose clamps to hold it all together while you weld it