DIY OIL LINES?
#23
Re: DIY OIL LINES?
Check with your local parts store, you can get push on fittings and hose made by Edelmann thats the same as Aeroquips socketless stuff for much cheaper. We used them on transmission cooler lines with no clamps and never have a problem, same with fuel and oil. No clamps, looks clean.
Push-On Hose Fittings
Push-On Hose Fittings are manufactured for low and medium pressure, these fittings are quick connecting and have high resistance to vibration damage.
Working temperature: -40 to 250 degrees F
Material: brass
Working pressure: up to 150 psi. Hose clamp is required when working pressure exceeds 100 psi.
Applications: fuel line, fluid and vacuum systems
Push-On Hose Fittings are manufactured for low and medium pressure, these fittings are quick connecting and have high resistance to vibration damage.
Working temperature: -40 to 250 degrees F
Material: brass
Working pressure: up to 150 psi. Hose clamp is required when working pressure exceeds 100 psi.
Applications: fuel line, fluid and vacuum systems
PUSH-ON HOSE
For use with Push-On Fittings
A superior quality hose recommended for fuel, oil, air, water tube and many other general purpose applications. Constructed for long life and extra duty. Resistant to oils, solvents, abrasion and weather. Quality construction. Seamless Hypalon cover and Nitrile tube. Angle woven high strength polyester cord braid tightens on fitting under pressure or tension allowing excellent coupling and holding ability with Push-On fittings. Meets S.A.E. J30R7 requirements.
Working pressure: 250 psi
Burst pressure: 1,000 psi
Temperature range: -40 degrees F to 257 degrees F (-40C to 110.8C)
For use with Push-On Fittings
A superior quality hose recommended for fuel, oil, air, water tube and many other general purpose applications. Constructed for long life and extra duty. Resistant to oils, solvents, abrasion and weather. Quality construction. Seamless Hypalon cover and Nitrile tube. Angle woven high strength polyester cord braid tightens on fitting under pressure or tension allowing excellent coupling and holding ability with Push-On fittings. Meets S.A.E. J30R7 requirements.
Working pressure: 250 psi
Burst pressure: 1,000 psi
Temperature range: -40 degrees F to 257 degrees F (-40C to 110.8C)
#25
Re: DIY OIL LINES?
Originally Posted by ChevyIIMan
Check with your local parts store, you can get push on fittings and hose made by Edelmann thats the same as Aeroquips socketless stuff for much cheaper. We used them on transmission cooler lines with no clamps and never have a problem, same with fuel and oil. No clamps, looks clean.
Thread
Thread Starter
Forum
Replies
Last Post
OneBadV6
Forced Induction
9
01-25-2011 05:45 PM
reinhardsen
Forced Induction
2
04-11-2003 12:11 AM