If for some reason my base timing was 10 degree off due to hardwares (distrubitor ect) fault, can I advance my whole table by 10 degree to compensate? or is there another way?

 

Why wouldn't you just adjust it correctly?

 

I would sugest that you put the timing to the OEM Specs. then adjust your map accordinglly. 98ctr

 

I would not be asking this question if things were that simple. My distributor is taking the plunge, even when I turned it all the way, it only goes up to 6degree at idle.

 

wait, save up some money, buy a f*cking dizzy and get your ---- running right instead of rigging it, blowing it up and the crying about it later.

 

Yes it will work. Use a dial-back light so you can get it dead on.

IMHO, if your tables say 15 at idle and your dial-back gun says 5 at idle, just add 10 accross the board in your maps. Ghetto, yes, but it will work. Just always have to keep that 10* in mind when staring at your maps