for the masters! I need help converting maps from P28 to pm6
#1
for the masters! I need help converting maps from P28 to pm6
As the subject says, I want to run my d16z6 obd0, I know some people have converted p28 maps and they were able to run them on a pm6.
any help would be greatly appreaciated.
any help would be greatly appreaciated.
#6
Re:for the masters! I need help converting maps from P28 to pm6
Maybe I should point out my logic as to do what I say...
First, both engines that run on either the pm6/p28 are SOHC's...I think either 1.5/1.6L
There is obviously VTEC in the P28 code though.
So throw in the PM6 maps....set your VTEC point high with your controller and tune all you can on the non-vtec lobe of the cam.
Then switch over to your VTEC point ~4400 and tune the VTEC above that. Now everyone knows that you put the VTEC point where the two power curves would cross but Im betting you dont have a Dyno so you would either have to make an educated guess or try to use your butt dyno where to place that point.
First, both engines that run on either the pm6/p28 are SOHC's...I think either 1.5/1.6L
There is obviously VTEC in the P28 code though.
So throw in the PM6 maps....set your VTEC point high with your controller and tune all you can on the non-vtec lobe of the cam.
Then switch over to your VTEC point ~4400 and tune the VTEC above that. Now everyone knows that you put the VTEC point where the two power curves would cross but Im betting you dont have a Dyno so you would either have to make an educated guess or try to use your butt dyno where to place that point.
Thread
Thread Starter
Forum
Replies
Last Post
crxboostin
Engine Management
8
03-13-2007 04:56 PM
projekteg
Turbo Parts For Sale
1
11-08-2005 09:07 AM