I am trying to burn an SST chip, and I keep getting the erroe message
"Error at 0x000000 Chip = 0xFF buffer = 0x02"

I can erase and read it just fine, but it writes up to 100% then gives me the error message. When i read the chip its blank(all FF)

Any help would be nice

 

in the software, set the offset to 8000, and set the yellow jumpers properly, you have should only have 1 yellow jumper in place on the row next to the zif socket when writing, and two on when erasing. also make sure your dip switches are set properly.

most likely, its the offset, because see how its error at 0x000000....with the offset, you're starting at 0x008000

 

Well i founf the problem, I had william selected and not PCB3 Oops...brain fart