model x

I'm using the enhanced willem burner and the sst27sf512 chips; I can read, and erase the chips fine but when I try to burn a bin says there's an error at 0x000000 chip= 0xFF buffer= 0x73

I'm stumped I've tried numerus chips, setting offset to 8000 etc

I have the power level on normal and the special chip setting on normal.

Has anyone else had this problem?

zebvaj

did you remove the jumper before programming the chip? Usually if you don't you get that error. Make sure you burn at 0x08000.

dohc

https://www.homemadeturbo.com/forum/...?topic=46879.0

even I got it to work lol....go here

IO_303

I started getting that error after a friend of mine put his chip in backwards into his ecu. It fried the chip and after we got a new one everything was fine

model x

again, I'm using the enhanced burner so there are no jumpers I tried burning at 0x08000 and I tried 3 different chips.

Does anyone else use the enhanced burner?

IO_303

Have you ever burned a chip on the burner?? are you sure your settings are righ and you have the chip in right?

model x

ya i've used it on amtel chips many times.
If the chip was in wrong it wouldn't erase and read the chip