Just got done trying 0.97j software. Did that in Willem 'mode' and in PCB3 mode for s&g's. On top of both modes I also did with and without the "8000" offset. I did remember to put the jumper on to erase and take it off to burn everytime so its not that. Any more ideas or hunches? Anything is greatly appreciated. Who knows, I might just have the Y-49 equivalent of a burner or computer for that matter.

 

Post screen shots of the errors you are getting...its so hard to troubleshoot this crap over the internet because we have no idea of the actual process you are using.

 

Using 0.97g software.

 

Using O.97ja

You have to ERASE the SST chip before buring a file to it. Also, you need to set your offset to 08000.

 

Burn and Erase

 

0.97ja same error but different offset (or whatever those hex numbers refer to.)

 

Are you sure the file you are trying to burn is exactly 32k (3276 ?

 

Yup, just checked all 4 I've tried right now. All 32768kb.

Am I retarded?

 

I dunno....you are erasing them before trying to burn? Every time....

Sometimes, it wont make it all the way through a burn...you might have to try 2 or 3 times. But you have to erase everytime before trying to reburn.

 

Same two errors. I erase prior to every burn. Is the offset 08000 or 8000? And does Radio Shack carry the AT29C256 chips?