RS-232 Bus-Pin ESD Protection Exceeds
±15 kV Using Human-Body Model (HBM)
Meets or Exceeds the Requirements of
TIA/EIA-232-F and ITU v.28 Standards
Operates With 3V to 5.5V VCC Supply
Operates Up To 250 kbit/s
Two Drivers and Two Receivers
Low Supply Current . . . 300 μA Typical
External Capacitors . . . 4 × 0.1 μF
Accepts 5V Logic Input With 3.3V Supply
Alternative High-Speed Pin-Compatible
　
RS232 to 3.3V to 5V TTL Serial Converter Cable This converter provides two way RS232 serial communications signal conversion between the TTL (Transistor Transistor Logic) output (from an OOPic or other PIC) to and from a personal computer RS232 serial COM port.

This converter can be used on any Micro controller which has TTL serial communications that needs to be converted to RS232. The cable converts 0v & 5v(3.3v) nominal TTL signal to –12v & 12v RS232 serial signal. This cable require 3.3V to 5V power from the TTL side to operate


here is the link
http://cgi.ebay.ca/ws/eBayISAPI.dll?...sPageName=WD1V



thank you

 

Sounds like it... How much is it? ..if it' smore than $23.. Well, there is a link to a board in the FAQ that will _for sure_ work.

 

it looks like it will, but i bought some off ebay once that 'should' have worked according to their description, but didn't. the guy was cool and refunded my money, but still, it was a waste of time. didn't you buy a cable from me with your ecu?

 

LoL, you are mistaken... i sold you an ecu! Never bought from you!
I'm going to check the local radio shack to se if i can find a nokia usb...
Thanks for your input

 

lol, you're right, for some reason i always mistake you for user 'vince_badazz', i have no idea why. damn canadians all look the same :P

 

I am going to test a Nokia datacable that I can get from work also (we use two kinds, one of them is bound to work). If it does.. I'll smuggle a couple out and and pass 'em out.