vtec on my B16
Ok so I have a chipped P06 with vtec but I have yet to hook up my 02 sensor so it's throwing an 02 code. I ran the vtec solenoid wire to the ecu and now I have a rev limit of 6500 and no vtec, is this because of the o2 code?? Once I fix that will I be all set?
|
Re: vtec on my B16
Yes. You could also disable your O2...
|
Re: vtec on my B16
I disable 02 in uberdata and it still throws the code :-\ Going to toss an 02 in now.
|
Re: vtec on my B16
No codes, hooked up an 02, no vtec, rev limit still at 6500. This is a vtec p06 done by a guy who knows what he's doing. Is something wrong in uberdata? That's all I can think of. If the ecu is good, and there aren't any codes... I don't need vtec coolant check or any of that right? I just have ELD, PA sensor, and vtec the only things that are checked...
|
Re: vtec on my B16
Does a B16A3 have a vtec oil pressure switch?
|
Re: vtec on my B16
Yeah but I thought in uberdata you only needed to wire the single wire for vtec solenoid since the p06 isn't looking for vtec oil pressure.
|
Re: vtec on my B16
Alex send me your .bin
|
Re: vtec on my B16
Originally Posted by nonvtec
Yeah but I thought in uberdata you only needed to wire the single wire for vtec solenoid since the p06 isn't looking for vtec oil pressure.
|
Re: vtec on my B16
Alex look under the Rev limits tab and look where the full throttle launch section is. Make sure your rpm shift cut isnt set too low. If that stuff in enabled.
|
Re: vtec on my B16
is the vtec solenoid grounded?
|
All times are GMT -5. The time now is 08:09 PM. |
© 2024 MH Sub I, LLC dba Internet Brands