using a pretuned map !!
#11
Re: using a pretuned map !!
survey says...
X X X
only use someone elses tuned map as your basemap...don't assume it's good. csaddict has almost the same setup as i do and i sent him my perfectly tuned afr 13-12 through the map and it was way rich on his car. the tune should be tuned specifically to your car and environment. you're already saving on running a diy engine management solution, but you'll still have to give up a little $$ to tune it.
X X X
only use someone elses tuned map as your basemap...don't assume it's good. csaddict has almost the same setup as i do and i sent him my perfectly tuned afr 13-12 through the map and it was way rich on his car. the tune should be tuned specifically to your car and environment. you're already saving on running a diy engine management solution, but you'll still have to give up a little $$ to tune it.
#13
Re: using a pretuned map !!
Originally Posted by Racintweek
here's a better question....why are people using DIY management IF THEY DONT WANY TO DO IT THIER SELF
#15
Re: using a pretuned map !!
i have a p28 ecu on a d16z6. running a t25 turbo. i want to run 10-11 psi stock block. i am gonna have the ecu set up for uberdata and would like to try it yself. i need it done asap really. a friend and i are going to attend a tuning glass in june but i want to learn what i can now. the class is $1000!!! a piece not including room and board and gas to get there. but i need a basmap if anyone has one. just a bin i can use to get started.
255 fuel pump
t25
hf mani
450 injectors
fmic
d16z6
also was wondering if i should install my head studs and use the cometic head gasket to run 9:1 compression ratio?
i als o have a wideband available and my friend has all software. we are both new at this and dont have any basemaps
255 fuel pump
t25
hf mani
450 injectors
fmic
d16z6
also was wondering if i should install my head studs and use the cometic head gasket to run 9:1 compression ratio?
i als o have a wideband available and my friend has all software. we are both new at this and dont have any basemaps
Thread
Thread Starter
Forum
Replies
Last Post
HMTdmc
Engine Management
8
12-06-2006 04:58 PM