I've been running a program that has the FTL enabled and was wanting to change the rpm limit or turn it off altogether. When i open the Bin that i've been running and turn off the FTL (simply unclick the checkbox), then reburn a new chip...the car will not start now i haven't changed any fuel/timing maps, all i did was unclick the checkbox. if i replace the original chip (same program, with FTL clicked) it starts/runs fine. i even burnt the original program onto the second chip (to verify the chip wasn't defective) and it starts/runs fine.

can anyone tell me what I'm doing wrong? I wish there was an Uberdata user's manual for dumbshits like me.

 

Reinstall Uberdata and try again or use a different version all together.

 

is this the only option? or just the first attempt to narrow down the problem.