uber datalogging problems
#1
Guest
Posts: n/a
uber datalogging problems
i have everything set up right (i think), but i continue to get messed up numbers (tps reads wrong and sometimes doesnt read quick hits of the throttle, temperatures are all off, mph is way off, only thing dead on is the rpm)....what am i messing up? And yes the baud rate is set right. Btw this is with a p28 with a p30 map.
#3
Re:uber datalogging problems
Ghetto what version of Uber are you running? Also what method of dataloging are you using (serial or USB)? I origionally had this problem but it wasn't reading the O2 sensor correctly. It ended up being the narroband output of the wideband controller screwing with the ecu's readings.
#6
#9
Re:uber datalogging problems
Ghetto,
If you dont solve the problem soon stop by and we will try the other cable I made. Then we can at least eliminate that as a potential problem.
The BINs I created and put in your ECU are from 1.7 so you probably have to be using that version of UD.
If you dont solve the problem soon stop by and we will try the other cable I made. Then we can at least eliminate that as a potential problem.
The BINs I created and put in your ECU are from 1.7 so you probably have to be using that version of UD.
#10
Re:uber datalogging problems
I was going to be using the Nokia cable for my dataloging but it was causing all sorts of whack readings and just not co-operating. I ended up switching the the Max233 serial type and it works flawlessly. So, it could be just a simple cable problem. Listen to your boy xeno
Thread
Thread Starter
Forum
Replies
Last Post