uber datalogging problems
 

i have everything set up right (i think), but i continue to get messed up numbers (tps reads wrong and sometimes doesnt read quick hits of the throttle, temperatures are all off, mph is way off, only thing dead on is the rpm)....what am i messing up? And yes the baud rate is set right. Btw this is with a p28 with a p30 map.

Re:uber datalogging problems
 

makes me look foward to hooking my uber-ecu up. I just chipped it last night even put a switch on the J1 and hooked up my usb cable. ill be super happy if it works with no problems first try.

Re:uber datalogging problems
 

Ghetto what version of Uber are you running? Also what method of dataloging are you using (serial or USB)? I origionally had this problem but it wasn't reading the O2 sensor correctly. It ended up being the narroband output of the wideband controller screwing with the ecu's readings.

Re:uber datalogging problems
 

im running 1.7 (even though when i go to open it it says 1.66) and im using usb. I dont have a wb so that cant be the problem :-\

Re:uber datalogging problems
 

That's not the newest release. You want 1.70 I use the new 1.8 where Blake adds Ostrich support and stepped retard works right.

Re:uber datalogging problems
 

Go here http://www.ecimulti.org/uberdata/for...;threadid=2001

Re:uber datalogging problems
 

CSaddict have you had any problems trying to save files through 1.8? I had a little lockup problem, but everything else worked fine :-\

Re:uber datalogging problems
 

No, I have saved a bunch and they all saved fine. Bigwig converted my 1.66 file for me because I couldn't get copy and paste to work properly.

Re:uber datalogging problems
 

Ghetto,

If you dont solve the problem soon stop by and we will try the other cable I made. Then we can at least eliminate that as a potential problem.

The BINs I created and put in your ECU are from 1.7 so you probably have to be using that version of UD.

Re:uber datalogging problems
 

I was going to be using the Nokia cable for my dataloging but it was causing all sorts of whack readings and just not co-operating. I ended up switching the the Max233 serial type and it works flawlessly. So, it could be just a simple cable problem. Listen to your boy xeno ;)