beater

sorry man, completly forgot about this. What you can do, and this may not be the best way by any means, is import in the stock pm6 maps. These maps are set up as 240cc. Then you can copy and paste(also making sure that your fuel multipliers are correct as I don't know of the pm6 and pr3 multipliers are the same) the fuel and ign maps into the ng48 rom. Say your Vtec point is 5500, paste low cam maps below this point and high cam maps above this point. Let me know if you have any problems. I did this for a customers car and it worked like a champ.

Again, this may not be the correct way to do this but I do know that it work.

If you want me to whip one up, let me know.

-Nick

projekteg

that's what i did, i didn't mess with the multipliers though, i was unaware that they may be different, he hasn't given me any feedback yet, so we'll see

Chris Harris

Do you have fuel multipliers set to Auto-Detect? If you do there should be no problems with the multipliers.

You never said which ECU you were using which plays a huge part...I am assuming PM6.

projekteg

yeah, pm6. no, auto detect is disabled, how do i enable it?

Chris Harris

i believe its under the File-->Properties area.

Its on by default so unless you turned it off...it will most likely be 'ON'

Using a PM6 its best to take the above advice and splice together low cam & high cam PR3 fuel & ignition maps. However...you need to understand that the NGxx series of ROMs only allow the computer to pick from REV columns up to 7400 RPMs. If the operator plans to rev higher you are going to need to enrich the last rev row to be safe.