tricks to desolder?
i cant seem to get a couple holes desolder on my ecu... any tips or tricks?
|
Re: tricks to desolder?
Braid right? Add more solder to get better heat transfer to the solder in the hole and use flux. |
Re: tricks to desolder?
get an actual desoldering station :y makes life WAY easier.
or just learn how to position your braid correctly. |
Re: tricks to desolder?
I also add solder to the two bastard holes, and then hit it w/ the braid again. Works well.
After awhile you will get better at using the braid, and the best way to position it. I used to cut the chips out of OBD0's w/ a dremel. O0 Now I can get em' out clean w/ just the braid, and no ripped traces. |
Re: tricks to desolder?
With the braid I like to insert the pin into the weave then lay my soldering tip on the braid. I also jump around on the chip so I don't over heat one section of the board. Just have some patience, play with it, and you'll get it...
|
Re: tricks to desolder?
I still use a dremel on pre chip ecu's have gotten a couple obd1 lately with them. Anywho also I like to do maybe 5-6 holes then let the iron rest for a little to get all that heat back works like a charm.
Just take your time ecu chipping is a bitch why everyone who starts doing it stops so bare with it |
Re: tricks to desolder?
Originally Posted by chris
Just take your time ecu chipping is a bitch why everyone who starts doing it stops so bare with it
Not everyone. I make good money doing it, and that's just local. These have been paid for many, many, many times over. Gotta use pro products. Having previous experience helps too. ;) http://www.hakko.com/english/product.../hakko_808.jpg http://www.hakko.com/english/product.../hakko_936.jpg |
Re: tricks to desolder?
Originally Posted by chris
Just take your time ecu chipping is a bitch why everyone who starts doing it stops so bare with it
|
Re: tricks to desolder?
I got a realy good soldering station(for electronics) and a manuel deolder sucker and also one te hooks up to air line and will suck the solder right out
|
Re: tricks to desolder?
Originally Posted by xenocron
Same with manifold makers...only a few of the true blue stick around O0
That's right Chris. We are few that take pride and do a professional job. From Solvent to Conformal Coat. |
All times are GMT -5. The time now is 07:35 AM. |
© 2024 MH Sub I, LLC dba Internet Brands