Setting up PLX M300 for datalogging (2 o2 bungs)
#1
Setting up PLX M300 for datalogging (2 o2 bungs)
Hey guys, I have a M300 permanently installed in my car... My DP Has 2 02 bungs. The stock sensor will stay and I'd like to use the WB sensor to check my A/F Ratio at all times.
How should I set it up in terms of the Grey and white wire and open loop/closed loop etc.
How should I set it up in terms of the Grey and white wire and open loop/closed loop etc.
#3
Re: Setting up PLX M300 for datalogging (2 o2 bungs)
Werd, Get a three way switch and hook the d14 ECU wire upt o the middle and then the sensors on either and, This way you can toggle back and forth between the two. I have my LC-1 wired up with a 3 way switch so i can toggle between narrow and wide so i guess it should work the same for yours.
Thread
Thread Starter
Forum
Replies
Last Post