Is rough idle typical with turboedit?
#12
Re:Is rough idle typical with turboedit?
import the stock map, and then do the basemap helper thing to correct it. importing a stock map will bump it back to 240cc injectors.
as for the basemap helper zeroing out, make sure you do not put "-31" or "-17" in the excel ------sheet. keep the numbers absolute.
as for the basemap helper zeroing out, make sure you do not put "-31" or "-17" in the excel ------sheet. keep the numbers absolute.
#13
Re:Is rough idle typical with turboedit?
when i enter the absolute numbers in the column headers it turns a few of the rows into zeros
im wondering if my stock pm6 bin that im using is an older one.. the column headers read in "InHg", whereas the new one reads just negative numbers.. but the numbers from the stock pm6 bin do match up with the headers on the first table on the helper that i paste into. does anyone know where i can get an updated bone stock pm6 bin from? thanks!
im wondering if my stock pm6 bin that im using is an older one.. the column headers read in "InHg", whereas the new one reads just negative numbers.. but the numbers from the stock pm6 bin do match up with the headers on the first table on the helper that i paste into. does anyone know where i can get an updated bone stock pm6 bin from? thanks!
Thread
Thread Starter
Forum
Replies
Last Post
Turblow
Engine Management
1
06-02-2006 04:09 PM
vani11aic3
Forced Induction
16
03-29-2006 08:42 PM
Slammd Sol
Forced Induction
4
03-14-2005 07:09 PM