possible burn1 problem
#1
possible burn1 problem
ok i have a buddys car with a chipped pr3 bought off ebay. whenever i burn a chip and put in it it acts like it has a 4k rev limit? the chip that came in it works fine but is not safe with outrageous high rev limit and low vtec.
here is my settings
BRE stock JDM PW0 map with 3,500 2step and no change in vtec or rev limit.
Burn1 loads to Flash & Burn
Flash & Burn Settings are SST-27SF512 chip start 008000 - 00FFFF Buffer start 000000 - 007FFF
chip burns and runs then 4,000 rpms hits a rev limiter. car is a 91 crx with b16a. the ebay chip works so who ever chipped the ecu did it right so it makes me beleave its my burner.
this is also on pgmfi's site but i never see anyone get help there.
here is my settings
BRE stock JDM PW0 map with 3,500 2step and no change in vtec or rev limit.
Burn1 loads to Flash & Burn
Flash & Burn Settings are SST-27SF512 chip start 008000 - 00FFFF Buffer start 000000 - 007FFF
chip burns and runs then 4,000 rpms hits a rev limiter. car is a 91 crx with b16a. the ebay chip works so who ever chipped the ecu did it right so it makes me beleave its my burner.
this is also on pgmfi's site but i never see anyone get help there.
#3
Re: possible burn1 problem
no check engine lights and if there was i would addressed them in this post his car runs on a stock pr3 with no codes the ebay pr3 has no codes but its whenever i burn a chip it runs funny.
Thread
Thread Starter
Forum
Replies
Last Post
94geeser
Engine Management
1
06-10-2004 07:08 PM