LEAN!! Car Goes Lean!! Cant Richen It Up. Cells Not Adjusting!!
#31
Re: LEAN!! Car Goes Lean!! Cant Richen It Up. Cells Not Adjusting!!
Originally Posted by Turblow
This sensor doesnt have 6 pins like the others, it has 4, fourth one was clipped when xeno sold it to me.
When everyone was screaming national backorder on Motorola 2.5 bar, I'm the hardcore backyard redneck that figured out that the riceboys got ahold of one part number and drilled it into nonexistance... found the SOP-8 and PMed the info to my main ***** xeno. :P
Do you have datalogging up and running? If you can see where the ECU is drawing fuel values from it might help you out a lot. You can substitute stock idle values in... they run a bit too rich, but you can start and idle a stock ECU on stock fuel values and DSM 450cc.
Where are you located?
#32
Re: LEAN!! Car Goes Lean!! Cant Richen It Up. Cells Not Adjusting!!
Yeah well like I said I dont even know if I have the wiring right, anychance you can verify what I posted up above as correct?
Im having no luck even getting the car to idle on its own, nothing is changing. I just need a bin to get me freakin idling and started and then I can go to work
And no I dont have any sort of datalogging. I was planning on running this car on TE this year and then next year funds permitting switch over to OBD1 and go Crome, get a laptop and all the fun stuff etc.
Turboedit doesnt seem to like stupid me though
I really need some help just getting it started.
Located way up north ontario canada
Im having no luck even getting the car to idle on its own, nothing is changing. I just need a bin to get me freakin idling and started and then I can go to work
And no I dont have any sort of datalogging. I was planning on running this car on TE this year and then next year funds permitting switch over to OBD1 and go Crome, get a laptop and all the fun stuff etc.
Turboedit doesnt seem to like stupid me though
I really need some help just getting it started.
Located way up north ontario canada
Thread
Thread Starter
Forum
Replies
Last Post
Turblow
Engine Management
0
08-04-2006 04:25 PM
W O T
Engine Management
9
07-13-2006 02:38 PM
Turblow
Forced Induction
2
07-05-2006 08:57 PM