Re: I dunno whats wrong.
 

Have you actually jumped the service connector, or did you just see that your light is solid when you turn the key to ON?

The CEL will always be solid until you jump the service connector. If it is still solid after you do that, then either the chipping job is bad (doubtful since Xeno did it) or you have a bad burn (most likely).

Re: I dunno whats wrong.
 

the flash n burn says it burned. never rev's above2K cold 1.2 warm. i know i'm puting the chip in right. i did the lil jumper thing and the light still stays solid.

Re: I dunno whats wrong.
 

Pretty much that means jack ----. It could still be a bad burn, or you are burning the bin incorrectly.

Re: I dunno whats wrong.
 

Yep, doesn't mean anything. Especially if the bin your are using is corrupt.

Re: I dunno whats wrong.
 

ok, here's the commen question.... how can i tell if the .bin is bad?

Re: I dunno whats wrong.
 

solid CEL means the burn was bad, or the ecu is jacked but i seriously doubt its the ECU, this was my main issue for switching from UD to hondata, i had soooo many issues with a decent burn and running issues from all the software not being finished, that i realized............


time is money, and i dont have alot of time

Re: I dunno whats wrong.
 

hey if you need to re-burn your chip bring your ecu to me and ill re-burn it and make sure you put it in right, if you need help let me know

Re: I dunno whats wrong.
 

i moved bro. i live in vegas now :/

this is the order i go in

1.UD mages change save .bin in UD folder.
2. erase chip
3. check blank
4.Load file to buffer.
5. programe chip.

am i missing any steps? or is just my flash% burn program/chip bad?

Re: I dunno whats wrong.
 

What chip are you using 29c256 or the newer SST 512's? You have to set the burner manually if you are using the SST chips.

Re: I dunno whats wrong.
 

not sure. but the chip # is 27sf512 if that helps any. :/