help!!..
#1
help!!..
ok, i bought the batronix EEprom programmer, put it all together, plug it in to the power supply and run a few checks to make sure its all fine and dandy, and its ok working fine, i can connect to it with the software included with it, but turbo-edit just freezes my computer everytime i try to burn a chip.?? and if it doesnt freeze, it closes the program. so i tried to burn the bin with the software included with the programmer and it says it cant burn the first byte. i dont know what is going on, but i know im tired of messing with it! any help would be greatly appreciated!
#2
Re:help!!..
TurboEdit doesn't have anything to do with the burning of the chip so you shouldn't be burning any chips with TurboEdit. I don't see how TurbpEdit can freeze your computer up while you are burning a chip.
I'm retarded so don't mind my stupid comments/questions.
Are you taking the .bin that you created in TurboEdit, saving it, opening it in the burner software, and then burning? Just trying to figure out what's going on.....
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
I'm retarded so don't mind my stupid comments/questions.
Are you taking the .bin that you created in TurboEdit, saving it, opening it in the burner software, and then burning? Just trying to figure out what's going on.....
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
#3
Re:help!!..
http://www.-------------/te/basemap.htm
when you convert and save.... you cant reconvert and save in the same bin.... it will cause it TE to freeze...
i hope that makes sense
you are just gonna have to save as a *new* bin and not save over a previously converted bin
there. i think that's better
when you convert and save.... you cant reconvert and save in the same bin.... it will cause it TE to freeze...
i hope that makes sense
you are just gonna have to save as a *new* bin and not save over a previously converted bin
there. i think that's better
#4
Re:help!!..
yes.. i saved the bin, opened the software included with the batroniz (i did this a few seconds ago to make sure i was following directions correctly) it wont let me erase the chip that is in it. the chip is "AT27C256R" if you need to know anything else about what im trying to do just ask.. lol.. im almost as lost as you
#5
Re:help!!..
Originally Posted by crx304
https://www.homemadeturbo.com/forum/...threadid=22925
when you convert and save.... you cant reconvert and save in the same bin.... it will cause it TE to freeze...
i hope that makes sense
you are just gonna have to save as a *new* bin and not save over a previously converted bin
there. i think that's better
when you convert and save.... you cant reconvert and save in the same bin.... it will cause it TE to freeze...
i hope that makes sense
you are just gonna have to save as a *new* bin and not save over a previously converted bin
there. i think that's better
#6
Re:help!!..
i saved it as a new file, opened "prog-studio" and opened it in there, clicked program IC, and it said "already programmed addresses cannot be programmed without preceding erasing of IC" yet it wont let me erase it.
#9
Re:help!!..
Originally Posted by crx304
aren't 27c256 uv erasable?
29c256 are electronicly erasable
29c256 are electronicly erasable
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
#10
Re:help!!..
well there we have it.. thanks alot for your help both of you! ill get a UV light tomorrow and try it out and hopefully i wont have to drive the 500 dollar hatch any longer.lol ill post up if i have anymore problems
Thread
Thread Starter
Forum
Replies
Last Post