Code 3 using TE
#1
Code 3 using TE
Just made a basemap for my mates twin cam D with turboedit and got a code 3 when I stomped on the gas, I thought that code 3 had been removed from the boosted roms, either it has been reinstated recently or could it be because the injectors exceeded maximum duty cycle in the boosted portion of the map?
#5
Re: Code 3 using TE
Originally Posted by xenocron
It was never added back in...hell, they havent done any development in months.
But, are you sure its not an actual MAP sensor problem?
But, are you sure its not an actual MAP sensor problem?
Is the map setup for Dual Map? Make sure it is, otherwise its just an NA map and has no boost area. (from what I remember... all my TE maps are boosted at this point )
#9
Re: Code 3 using TE
NG60_18
TE 2.5.0.5 from pgmfi
didnt use xeno's basemapper, there is no need as of yet i was just wanting to test it out.
I'm going to download NG60 again, and use 2.5.2 to modify the map.
There is nothing wrong with the wiring as it was fine when it was NA and nothing else has changed
TE 2.5.0.5 from pgmfi
didnt use xeno's basemapper, there is no need as of yet i was just wanting to test it out.
I'm going to download NG60 again, and use 2.5.2 to modify the map.
There is nothing wrong with the wiring as it was fine when it was NA and nothing else has changed
#10
Re: Code 3 using TE
Make sure you download and install TE from www.turboedit.org (version 2.5.2)
Then goto http://forum.pgmfi.org/viewtopic.php?t=7520 and download the 2.5.5 exe file into your TE folder.
Running that and using the NG60 maps... you should have 0 issues.
Then goto http://forum.pgmfi.org/viewtopic.php?t=7520 and download the 2.5.5 exe file into your TE folder.
Running that and using the NG60 maps... you should have 0 issues.