Cant get turboedit to data log?
 

I Have a pm6 and a data loger that I installed the other day. I also Download TurboEdit Version 2.6.1 From chris. I cant figure out how to make it work, or the order to set up the dataloger features. If some one has a step by step that thay could point out, it would help out.

Re: Cant get turboedit to data log?
 

the TE datalog is hard to get to work just search yahoo or goggle and download ecucontrol 5 or whatever the latest version is and try again

Re: Cant get turboedit to data log?
 

I disagree...the version posted on my site is the only I can get to work.

You must be using NG60 code 1st! And your drivers must installed properly and your COM ports setup accordingly...

Re: Cant get turboedit to data log?
 

thanks chris i may try that out have you set it up on win 98 or have you mostly used xp? it wont work ng55 or ng48?

Re: Cant get turboedit to data log?
 

I tried the ng55 and I couldent get it to work, Chris said it had to be a ng60 so I burned a ng60 and I still couldnt ge tit to work. :7 I want to smash this ---- all over the street. Its so ------- frustrating!!!!!

Re: Cant get turboedit to data log?
 

He also said to make sure your COM ports are set correctly.

Re: Cant get turboedit to data log?
 

I tried every com port that I coud and still nothing.

Re: Cant get turboedit to data log?
 

are you getting any error messages?

Re: Cant get turboedit to data log?
 

Only when it was in the wrong port. I can get it to conect, then I press start loging and the light on the usb conector starts blinking green, but nothing shows up on my screen. If I press the active dash everthing gos all fucked up. It says that im doing 65 mph and my water is like 165* and my intake temp is 165*, but im just at idle.

Re: Cant get turboedit to data log?
 

TOOLS --> OPTIONS--> Communication

#1 - Set datalogging to the COM port assigned by your drivers (find this in the device manager, dont just try random COM ports)

#2 - Set real time programming to the proper COM port or something other than your datalogging port if not using Ostrich

#3 - Baud Rate 38400

APPLY AND CLOSE

FILE --> DATALOGGER

Connect

Start Logging