2.5bar motorola map problems
#1
2.5bar motorola map problems
I had just converted from my stock map to my 2.5motorola on my turbo singlecam and Freelog is telling me that the map is reading 13.2in lb of vac with the car off and ign on. its wired right also because it reads change in vac but it goes to 13.2 when reading atmospere. Anyone ever get this same situation or is it just a bad map? just pulled it outta the bag it came from xenocron so i didnt think that was the issue.... any way i can offset that with the right amout of resistance? thnx guys
I also scaled everything on crome for the 2.5motorola and setup VE base tables.
I also scaled everything on crome for the 2.5motorola and setup VE base tables.
#3
Re: 2.5bar motorola map problems
thats funny 2 of my buddys 2.5 just ---- the bed they are fine in vacume and boost if you baby i but anything above 1/2 throttle and they lean out and pop converted back to stock maps and there cars are fine. Mabey xeno got a bad batch
Thread
Thread Starter
Forum
Replies
Last Post
#Leo#
Engine Management
25
12-02-2008 04:52 PM