projekteg

i need some (three to be exact) of the little bolts that you loosen to rotate the compressor housing, they're the really short ones, the washers would be nice too, but mostly just need the bolts.

freakaccident

Check a bolt shop. Look in the phone book under fasteners. We have a shop near me that has never let me down. Worth a shot anyway.

projekteg

i was thinking of lowe's or home depot, but these bolts are really short and i've never seen a bolt this short before

ZC4ME

If you can find that right thread and pitch etc, buy the bolts and the nuts to go with them. Then, take them home, thread the nut onto the bolt, cut the bolt off to the desired lenght and then remove the nut to clean out the threads from the cut. This should work.

peace
Griff

ZC4ME

Oh yea, I am pretty sure it would be obvious, but make sure you get a grade of bolt that can withstand the temperatures that it will be subjected to. I guess they are not really going to be in a high stress situation, but they could become brittle and break from vibration or whatever.

Griff

projekteg

good idea, i was thinking about cuttin some down but was worried about the threads where i cut

ShadowRex

use a cut off disk on a grinder or a dremel and a steady hand


Griff call me tomarrow (wendsday) lol

projekteg

WTYM (word to your mother....)

LoSx

they are usually the same thread and pitch as the larger outside ones... home depot carries them I think they are metric bolts usually 8 mm if im not mistaken...

when i get home ill post up what I am pretty sure shuld fit it... bring the turbo to homedepot and when pople arent lookin open the bag a lil and screw em in to make sure...

im fairly sure home depot shuld have em tho!

booley

look in the yellow pages under "industrial fasteners" or just "fasteners" or "bolts". there should be something in your area...they would have a much larger selection than home depot. they should be able to find exactly what you need.....