This is hmt; its about not spending a ---- ton of money to go fast.

 

Thats what I'm trying to do, I'm trying to save my money. I'm gonna post it on fabrication.

 

https://www.homemadeturbo.com/forum/...?topic=83294.0

If you're a baller.

https://www.homemadeturbo.com/forum/...?topic=96426.0

 

What a peas of ----..........I need something alot biger and I want to make it right.

 

you dont need something near as big as you think unless you have just barely enough compression for the engine to run

 

Yah, really low compression, like 152-155...

 

is it low cause of low comp pistons or low cause its worn out? there is a difference

 

Tony1's catchcan's don't cost that. $250-290 IIRC, come with all fittings and stuff.

Try campaigning a 450+ whp drag car with dual Moroso catchcans and the valvecover vent one just fills up and leaks all over the track because that catchcan isn't big enough. It makes you look like a dumbass, and pisses off the track. For the sort o gear you buy, and what you get, it's a good price.

I'll be running a $50 belt driven Gast pump, but what I'd charge someone else for it after I make a pulley, brackets, lines, etc, would be one a line with what the bare pumps go for out of a Slummit catalog.

 

It has JE low compression pistons 9.0:1, Eagle rods. 81.5 bore and Cometic head gasket...

 

Good to be a machinist...........