MikeJ-2009

Buyer fell through on my old motor. Here's the specs.




D16y8 about 4k miles on it now.
block posted
.10 over srp pistons
eagle rods
federal mogul bearings (.015 clearance)
fully rebuilt stock head w/mild port cleanup
arp head studs
y8 intake manifold
ls throttle body
All machine work on this motor is flawless.
All new bearings, gaskets, seals, ect. everything

This was my OWN motor, so I did the break in and all of that as if it were mine. When I moved, I didn't have a way of getting my car to Mn. so I parted it out.
When I took this out it had a small amount of smoke at idle. I was in a rush to get it out of the car and do the moving thing, so I never compression tested. I'm thinking either the rings in one cylinder lined up, or one of them cracked. It also has 3 cracked valve cover bolts. (thanks bamboo :P) Either way, I don't have a car for this motor, so $1000 is good for me. Located in Minnesota

MikeJ-2009

I don't want to part it out because this motor is .10 over perfectly matched to the pistons and crankshaft is just dead on .0015 for the rods and mains, so if I part out one piece, I'm stuck with half of a custom motor. :P

bambooseven

plus if he was going to part it out you wouldn't be getting any of it anyway.

bambooseven

steve, put it in the EG, just long enough to bow up yo're cute little auto tranny.

Cray91

No tranny with this I am assuming. I just ask because I was gonna build a D up and would need a trans too, but I can find one elsewhere I suppose.

MikeJ-2009

Nope, the tranny I was using I got from Julio for free. It had a somewhat grind going into third, and when I took it out I felt it was only right that I pass the tranny along, so I gave it to Murdoc.

FooK

stealthy gimme a price shipped to 97006, maybe ill go this route in the near future.

Guy-Fast

Good price

MikeJ-2009

where's 97706?

My wife has a pretty good shipping discount through her work, so I'd say $100 shipped anywhere and you can get it.