Swapping gears for mpg (question)
Guest
Posts: n/a
Swapping gears for mpg (question)
I plan on running a B16 trans on my daily, but because of the 4.4 final drive, it's not too good on the highway. I know it's possible to swap gears out of a ls trans, so you can have a long fifth gear. Can anyone tell me what all is needed to make this work? Both of my trans are small shaft, 1 gen's. Thanks guys.
3.0 BAR
Joined: Mar 2006
Posts: 5,631
Re: Swapping gears for mpg (question)
Originally Posted by boostedhfrex
It should be a decent setup when its done. Alot of local N/A guys run the ls final and swear by it
89HAtchnig: Youre lucky you get through the traps in fourth!!!!!
LOL
1.0 BAR
Joined: May 2008
Posts: 308
Re: Swapping gears for mpg (question)
Originally Posted by bigdaddyvtec
Not the final dickweed... Only the fifth set. Its an EASY swap....
89HAtchnig: Youre lucky you get through the traps in fourth!!!!!
LOL
89HAtchnig: Youre lucky you get through the traps in fourth!!!!!
LOL
Guest
Posts: n/a
Re: Swapping gears for mpg (question)
Originally Posted by bigdaddyvtec
Not the final dickweed... Only the fifth set. Its an EASY swap....
89HAtchnig: Youre lucky you get through the traps in fourth!!!!!
LOL
89HAtchnig: Youre lucky you get through the traps in fourth!!!!!
LOL
Yeah, I was worrying about that. When I was running my all-motor setup, in my Rex, I was going through the traps over 8 grand in fourth. I don't plan to drag this car as much as my last though, so I'll give up a little time in the quarter, for better driveability.
3.0 BAR
Joined: Sep 2004
Posts: 1,588
Re: Swapping gears for mpg (question)
Originally Posted by Mista Bone
need a 5th gear SET, thats 5th gear of both shafts 90-91 LS tranny.
BTW, Honda doesn't have any left, don't think I do either.
BTW, Honda doesn't have any left, don't think I do either.
3.0 BAR
Joined: Sep 2004
Posts: 1,588
Re: Swapping gears for mpg (question)
I won't, that's only to tell if it's 90-91 or 92+. I'm asking how to tell what gears would be in it. If I want to put an ls 5th in my b16 and if they both need to be 90-91 then obviously they'll both have the small shaft.
