I searched and cant seem to find the page where it was asked before....Now what it is i wanna know is, Can i remove the Internal wastegate and weld the gate shut, Buy a external Wastegate manifold with wastegate, and be just fine?

 

what turbo?

 

oh my bad, its a 2 gen dsm t25...

 

You could remove the wastegate flapper and fill the hole on the side. Run the ext. wg from the second hole on the t25 dp flange. might wanna port the lip on the turbine housing in this case.

You could leave the stock int. wg and just remove the vacuum source. Run an ext. wg on the mani.

You dont need to buy a new mani!

 

ok, so it can be done, now the way i said earlier, could that work to..Weld the flap completely shut, then just plug the Dump part for the wastegate on the dp flange..Then i could put an external up top on the manifold...
See cause i wanna remove the IW for good due to lack of room...

 

right.
here is the first suggestion:

 

So in this pic here, i would leave the flapper open and just remove the vac source and wastegate..correct?

 

omfg i want that bad for my 91 accord!!!!

 

----, you would get less boost creep with the stock gate then that