Internal to external Wastegate...
#1
Internal to external Wastegate...
I searched and cant seem to find the page where it was asked before....Now what it is i wanna know is, Can i remove the Internal wastegate and weld the gate shut, Buy a external Wastegate manifold with wastegate, and be just fine?
#4
Re: Internal to external Wastegate...
You could remove the wastegate flapper and fill the hole on the side. Run the ext. wg from the second hole on the t25 dp flange. might wanna port the lip on the turbine housing in this case.
You could leave the stock int. wg and just remove the vacuum source. Run an ext. wg on the mani.
You dont need to buy a new mani!
You could leave the stock int. wg and just remove the vacuum source. Run an ext. wg on the mani.
You dont need to buy a new mani!
#5
Re: Internal to external Wastegate...
Originally Posted by whiterice
You could remove the wastegate flapper and fill the hole on the side. Run the ext. wg from the second hole on the t25 dp flange. might wanna port the lip on the turbine housing in this case.
You could leave the stock int. wg and just remove the vacuum source. Run an ext. wg on the mani.
You dont need to buy a new mani!
You could leave the stock int. wg and just remove the vacuum source. Run an ext. wg on the mani.
You dont need to buy a new mani!
See cause i wanna remove the IW for good due to lack of room...
Thread
Thread Starter
Forum
Replies
Last Post
djay86
Forced Induction
10
11-26-2005 03:56 PM