For the past few days i have been buring a chip and trying to make my cars idle not jump.

Spec's:

b16a in 91 dx
basic add ons fuel rail intank headers.

Po6 ecu chiped with a GSR burn.

so far i have the cold warm and moving idle speed at 1 and it still idles around 1.5K and the idle jumps. the IAVC i'v gone from -1 to 5 and it stil dose it. but very slightly. Could there be anything else wrong with the car/wireing? i also have knock sensor unchecked. injctor test disable,closed loop disable and VTP disable all unchecked. please help me on this!!

edit: using uberdata.

 

Not that it would effect your idle but did you convert your P06 to run VTEC? Have you tried different versions of Uberdata?

 

I'm using 1.70 from http://uberdata.pgmfi.org/forum/index.php?board=11 there is one thing i cant find in it. is the check egine light is solid and its like the fan is backwords. it only runs when the egnition is on but when i start the car the fan wont come on even when the car is fully warmed up. and yes the vtec is checked and the vtec <20mph is checked.

 

You aren't understanding me. You can't run VTEC on a P06 ECU if it has not been modifed internally.

 

oh... i'm not sure...xenocron chiped the ecu. i told him to make sure it had vtec :/

 

Then its fine.

 

ok, is there any other reason why the engine light would be solid. and the fan wont run when the engine is on? i never tuched the fan wise in the swap of ecu's and engine swap.

 

Temp switch.

 

solid light usually means it was a bad burn. well most of the time, does the car rev beyond 3k rpm?

 

Have the chip in right? Burner set right? Saved correctly?