The turbo I'm using is oil and watered cooled. I may have to rotate the compressor so it pointing up but the water cooling inlet may be in the way. I've heard at only 6PSi that you really don't need the water just oil but still I'd like to have the water runnning just to be safe but I'm trying to figure any ideas on how to bend or move it away. I was thinking of just cutting the hard like up to the point where it connect to the turbo just leaving enough to connect my line to it. Or what if I just used a small tourch and heated up the line and just bend it the way I want being careful not to kink it. Would heating up the hard line enough to b able to bend it easly damage anything ? Thanks

 

cutting the brass line and connecting fuel(soft) lines with a small clamp will work fine. i would rather have my compressor facing down, just my .02 cents