No water cool needed @ 6PSi ?
#1
No water cool needed @ 6PSi ?
The turbo I'm using is oil and watered cooled. I may have to rotate the compressor so it pointing up but the water cooling inlet may be in the way. I've heard at only 6PSi that you really don't need the water just oil but still I'd like to have the water runnning just to be safe but I'm trying to figure any ideas on how to bend or move it away. I was thinking of just cutting the hard like up to the point where it connect to the turbo just leaving enough to connect my line to it. Or what if I just used a small tourch and heated up the line and just bend it the way I want being careful not to kink it. Would heating up the hard line enough to b able to bend it easly damage anything ? Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Turbodelsolman
Forced Induction
13
10-23-2003 01:44 PM
Sinner
Engine Management
3
04-01-2003 09:06 PM