OBD2 to OBD1 conversion... using the y8 manifold, so I don't have a spot in the manifold (like onyx showed me is how it was done on the z6 motor) for my IAT sensor.
I've got it directly inserted into the intake filter right now, but where would you have put it in the same spot or possibly somewhere else?

 

close to the TB? drill and tap a hole in the intake tube.?

 

Close to the TB. Especially if your boosted. You are right?

 

Just slightly worried about the IAT falling out of the hole! I'll give it a shot, maybe JB Weld will come in to play again (evil grin)

 

should be ok... just a lockwasher or locknut or some loctite.. lock something!!

the reason i put " close to the tb?? " was cuz i wasn;t sure.

 

Why use an intake air temperature sensor? Maybe to keep from throwing codes, and giving the ECU correction? :P